Cut Flower Care Instructions
Step 1 – Remove the Composition
Grab the base of your composition with both hands. Tightly holding the stems together, remove the composition. Rinse the stems well while holding tightly.
Step 2 – Cut Back Stems
Using a small, sharp paring knife, cut the stems a half inch at an angle. This will improve the stems' ability to absorb water. Using scissors or clippers reduces hydration about 40% because it crushes the outer cells of the stem, which absorb most of the water.
Step 3 – Change the Water
Wash out the vessel with warm water and white vinegar to remove any traces of algae. Refill with clean, fresh room temp or cold water. Ideally, change your water every 3-5 days – before the water turns murky. Murky water means algae is present, which limits the hydration of your blooms. Be sure to fill up your vessel with water to the top.
Step 4 – Replace Your Composition
Still holding tightly to the stems, turn your composition at an angle as you insert it back into the vessel. Once inside, press down firmly so that the bottom of the stems touch the vessel. Straighten your composition to center and adjust as needed.
Naturally, some stems fade more quickly than others. Simply remove those. You may also notice that some spring bloomers will continue to grow in your composition (tulips, anemones, hyacinths, ranunculus). You can pull on the stem from the base and shorten them as you cut back stems.
Do I need to add anything to the water?
We're asked this all the time, and the answer is no. While we do sell food grade hydrogen peroxide to help keep your stems at maximum hydration and eliminate bacteria, this is not necessary. Changing your water often will do the trick!